Honeywell RTH230B нұсқаулық

Honeywell RTH230B
9.2 · 2
PDF нұсқаулық
 · 4 беттер
Ағылшынша
нұсқаулықHoneywell RTH230B
RTH230B 69-1800 2/6/05 1/4
The RTH230B programmable thermostat can be used to control:
a gas, fuel oil or electric furnace - 2 or 3 wires
a central air conditioner - 2 or 3 wires
a hot water system with or without pump - 2 wires
a millivolt system - 2 wires
a central heating and cooling system - 4 or 5 wires
Note: These thermostats are not compatible with heat pumps or
multi-stage systems.
Features
System operating mode selection: heat, cool or off
Fan operating mode selection: automatic or on (continuous)
Programmable heating and cooling cycle lengths: 10, 12, 15, 20
or 30 minutes
Temperature display in °F or °C
Battery replacement indicator
5-2 programming including:
- Preprogrammed energy-saving schedule
- Early Start
- Temporary bypass
- Time display (12 h or 24 h)
Filter replacement indicator

2.1 Removing the Old Thermostat

IN ORDER TO AVOID ANY RISK OF ELECTRIC SHOCK, CUT
POWER TO THE HEATING SYSTEM.

n Remove the old thermostat to access the wires.

Warning: If the old thermostat was mounted onto an electrical box,
it was probably powered by 120/240 volts. In this case, this thermo-
stat cannot be used.
o Identify and label each wire (with the corresponding letter on
the wire terminal) and remove them from the terminals.

p If necessary, strip the end of each wire (maximum of 1/4 inch).

q Wrap the wires around a pencil to prevent

them from falling into the wall.

r If the hole in the wall is too big, insulate it

using a non-flammable material in order to
avoid air draughts behind the thermostat.

2.2 Installing the New Baseplate

For a new installation, choose a location approximately 5 feet
(1.5 m) above the floor and on an inside wall. Avoid draughty
areas (top of staircase, air outlet, etc.), dead air spots (behind
doors), direct sunlight or areas near concealed pipes or chim-
neys.

n Remove the thermostat faceplate.

o Loosen the locking screw to separate the thermostat from its

baseplate (the screw cannot be completely removed).

p Tilt the thermostat upwards.

q Mark and bore the appropriate mounting holes (or use the

existing holes). Insert the plastic anchors.

r Pass the wires through the opening of the baseplate and fix the

baseplate to the wall using the screws provided.

2.3 Connecting the Thermostat

The connection of the new thermostat should be similar to that of
the old thermostat; however, it can vary depending on the installa-
tion.
Note: The red jumper wire between the Rc and Rh terminals must
be removed in 2- or 5-wire installations. The jumper must be used in
3- or 4-wire installations if you wish to use the mode selector switch
for the fan.

1. Introduction

2. Installation

RTH230B

Programmable Electronic Thermostat

Installation and User Guide

Display
Adjustment
buttons
System operating
mode selector
Fan operating
mode selector
Programming
buttons
Rh Heating power supply
Rc Cooling power supply
W Heating signal
Y Cooling signal
GFan

Honeywell RTH230B үшін нұсқаулығын мұнда қараңыз, ақысыз. Бұл нұсқаулық термостат санатқа жатады, оны 2 адам 9.2 орташа көрсеткішпен бағалған. Бұл нұсқаулық келесі тілдерде қол жетімді: Ағылшынша. Honeywell RTH230B туралы сұрағыңыз бар ма? Cізге көмек керек пе? Сұрағыңызды осында қойыңыз

Көмек қажет?

1 2 туралы сұрағыңыз бар ма, жауап нұсқаулықта жоқ па?

  • Шешімдер туралы жаңартуларды алыңыз
  • Сұрағыңызға жауап алыңыз

Сұрақ-жауап

Сұрақтар саны: 0

Honeywell RTH230B - Қондиционерлер үшін қатын-қосалқы термостат. Бұл термостат арнайы сенсор арқылы таңдалған температура түрлерін өлшейді, оны байлап отырған пайдаланушының қажеттіліктерін ескеріп, қоғамдық жұмысын тиімді жасайды. Бұл құрылғы жылдам ену жүйелерімен үйлесімді, қолданыстағы барлық құбырлар тіс бойынша өзгертіліп, жандылығы жақсы болып табылады. Honeywell RTH230B термостаты, табиғи мүше арқылы жылдам ену бірліктерімен енгізілген компоненттермен тұрған. Олардың біртік параметрлері үшін қолайлы, Қатаң тарту әдістерін қолданып, ергек жағынан түсіну мүмкіндігі жоқ. Honeywell RTH230B термостаты, қолданушыға жай жағдайға жақсы қор жобалары ұсынуға мүмкіндік беретін пайдалы уақыт заңдығы параметрлері бар. Мысалы, ол күнгі бірде орында тез айналады және қиқымды, ыңғайлы және тетікті етеді. Ол қоңырау салғышты аяқтағанда, у түрлендіру немесе жоғалтуға болады.

Жалпы
БрендHoneywell
ҮлгіRTH230B
Өнімтермостаттар
ТілАғылшынша
Файл түріПайдаланушы нұсқаулығы (PDF)

Нұсқаулықтан сұрағыңызға жауап таба алмайсыз ба? Сіз 1 2 сұрағыңызға жауапты жиі қойылатын сұрақтардан төменде таба аласыз.

Термостатты орналастырудың қай жері жақсы?

Термостат үшін ең жақсы орын - сіз көп уақыт өткізетін бөлме, көп жағдайда қонақ бөлме немесе ас үй. Термостатты еденнен шамамен бір жарым метр биіктікте қойыңыз, күн сәулесінде және сыртқы қабырғаға қоймаңыз.

Термостаттың өлі жолағы дегеніміз не?

Егер сіздің термостатта өлі жолақ болса, сіздің қондырғыңыз «тыныштық күйде» болады. Термостат, мысалы, айырмашылық орнатылған бөлме температурасынан 2˚C артық ауытқыған кезде ғана қосылады.

Бөлмедегі идеалды температура қандай?

Көптеген адамдар бөлмедегі оңтайлы температура 19-22 градус Цельсий аралығында екенін біледі.

Honeywell RTH230Bүшін нұсқаулығы Қазақтілінде қол жетімді ме?

Өкінішке орай, бізде Honeywell RTH230B үшін нұсқаулығы Қазақ тілінде қол жетімді емес. Бұл нұсқаулық Ағылшынша тілінде қол жетімді.

Сіздің сұрағыңыз тізімде жоқ па? Сұрағыңызды осында қойыңыз

Нәтижелер жоқ